On the route · Meridian
The rest of the lineup
Same $99 diagnostic, same written quote, same written warranty on every machine we fix in Meridian.
Meridian’s kitchens were built in the last twenty years and most got one of two ranges: a gas range on the streets with gas service, or a builder-grade glass-top everywhere else. Both are out of warranty now. A burner that clicks in Paramount or an oven baking cold in Ten Mile Crossing is ten minutes from the shop. The technician meters it and writes one price.
Mon–Fri 8am–6pm · Sat 9am–3pm · Sunday closed · same-day windows for a warm refrigerator
Same $99 diagnostic, same written quote, same written warranty on every machine we fix in Meridian.
Turn off Ustick into any Meridian subdivision and the kitchens follow a pattern. In Paramount, Lochsa Falls and the newer streets around Ten Mile Rd with gas service, the builder installed a gas range, usually a freestanding Whirlpool, GE, Samsung or Frigidaire. In Tuscany, Bridgetower and much of the townhome stock near The Village at Meridian, it was an electric glass-top from the same brands. The houses are now five to twenty years old, and the igniters, spark modules, radiant elements and sensors that came with them are at the age where they fail. The truck from Five Mile Rd carries those parts and is in Meridian in ten minutes.
A call from a 2012 house in Lochsa Falls went like this. The gas oven had been slow to heat for a month, then stopped heating at all while the burners on top still lit fine. The technician read the igniter and found it glowing but drawing too little current to open the safety valve. That is the most common gas oven failure on the route and it is a truck-stock part. Igniter replaced, oven checked against a thermometer at 350°F, a quick leak test on the gas side, written warranty left on the island. Meanwhile the neighbor’s identical range, installed the same month, has maybe a year left on its own igniter.
A weak igniter that glows but cannot pull enough current to open the safety valve. The technician clamps a meter on the igniter, reads the current, and swaps it from the truck. On the gas ranges Meridian’s builders installed between 2005 and 2018, this is the most frequent oven call.
A fouled or wet igniter electrode after a boil-over, a spark module failing, or a burner cap off center. The technician cleans the electrode, meters it, checks the module output and replaces whichever failed. If all burners click at once, a spark switch has shorted.
An open radiant element, a failed limiter, or a control board relay. The technician lifts the glass, meters the element and limiter first and names the board only when the readings leave nothing else. Elements for the builder-grade brands ride on the truck.
A temperature sensor reading high, a bake element with a burned spot, or a door gasket that shrank in a dry Idaho winter. The technician checks with a thermometer, meters the sensor and element, and looks at the gasket before quoting.
A door lock motor stuck after a self-clean, a sensor that failed from self-clean heat, or a control board. The technician reads the code, meters the lock and the sensor, and quotes the board only when the meter proves it. Self-clean is hard on builder-grade sensors.
A failed convection element or a relay on the board. The technician meters the convection element, the bake element and the relay output, and names the one that has failed. This shows up on the convection ranges in Meridian’s 2015-and-later houses, where the convection element is the usual answer.
The technician works the cooktop first, then the oven. On a gas range that means watching each burner light, then reading igniter current and the flame pattern through a full oven cycle. On a glass-top it means resistance on each radiant element and limiter, sensor resistance against the chart, and voltage at the terminal block, because a lost leg of 240V makes a Meridian oven look dead when it is not. A thermometer inside the oven settles any argument with the display. The door gasket gets checked. Then one part is named, one reason is given, and one price is written with the $99 diagnosis inside it.
The truck carries igniters, spark modules, radiant elements, bake and broil elements, sensors, limiters and infinite switches for Whirlpool, GE, Samsung, Frigidaire, LG, KitchenAid, Maytag and Bosch, which is nearly every range in Meridian. Rentals in Tuscany, near The Village and around Ten Mile Crossing run through the tenant with the owner approving by text and receiving the invoice and written warranty by email. Every range in 83642 and 83646 gets the same rule: the $99 diagnostic is inside the number you approve, $99 is the whole bill if you decline, and all pricing comes after the diagnostic, in writing.
Yes. Much of Paramount, Lochsa Falls and the newer streets near Ten Mile Rd have gas service and gas ranges. The technician handles igniters, spark modules, safety valves and burner assemblies, and tests for leaks after any gas-side repair before leaving.
On a gas range they are separate systems. The cooktop burners use spark igniters; the oven uses a glow igniter that must draw enough current to open the gas safety valve. When that igniter weakens, the oven goes cold while the top still lights. It is the most common oven repair in Meridian.
Usually. A radiant element or a limiter is a modest part and the rest of the range is fine. The technician gives you a written price and a plain opinion on the range’s condition. If the control board has failed on an older unit, that goes in writing too so you can decide.
Same week and often next day. Meridian is ten minutes down Ustick or Eagle Rd, so a range call in Paramount or Tuscany fits into most days. A burner stuck on high or a gas smell moves to the front of the schedule. Early and late windows exist for shift workers.
Yes. The tenant meets the technician, the diagnosis happens at the range, and the written price goes to the owner or property manager by text. On approval the repair proceeds, and the invoice and written warranty are emailed to the owner.
Call (208) 813-1132 or send the form. Most requests get a callback within the hour in business time, with a real arrival window.
The technician tests the machine with a meter, names the failed part in plain words, and writes one flat price. The $99 is already inside it.
We stock the high-failure parts for the brands Treasure Valley homes actually own, so most jobs close on the spot; ordered parts return with no second trip fee.
Full test cycle before we pack up, a tidy work area after, and a written warranty in your hand.
One call starts it: $99 diagnostic, one written number, repair from the truck, written warranty.
